¡¡¡¡¡¡1. Switch on power and insert air pipe. ¡¡¡¡ ¡¡ ¡¡ 2. Load proper nickel bands and lock nickel sheet pan firmly on nickel sheet rack.
¡¡¡¡¡¡3. Lead nickel band: Use tweezers to pick out nickel sheets from nickel sheet pan; use hand to lift unidirectional
bearing support; insert nickel band through two rollers; release unidirectional bearing support; press nickel band
properly; use another method to press nickel band (after passing positioning channel) between a second directional
¡¡¡¡¡¡¡¡bearing support.
¡¡¡¡¡¡4. After nickel band is properly inserted, insert it between Feed Cylinder guiding block and Press Cylinder and then
insert nickel band out of the final positioning channel.
¡¡¡¡¡¡5. Press Manual Feed button and observe whether the length is suitable. Adjust Limit Screw to desired position and
press Manual Cutting button.
¡¡¡¡¡¡6. Press START button and the machine will cut automatically. ¡¡Important: ¡¡¡¡¡¡ ¡¡¡¡¡¡1. Before starting manual cutting, check if cutting tool corresponds to cutting point on base and adjust cutting tool up
and down to proper position.
¡¡¡¡¡¡2. When testing the machine, never put hand or any other object on the cutting point.
¡¡¡¡ 3. There is a water-filtering bottle on the air-inlet device. When the machine is running for a long time, ensure that
there is no water buildup in the water-filtering bottle. When there is any water buildup, discharge it immediately (to
discharge, use hand to push in the water outlet at the bottom of the water-filtering bottle) to ensure proper